A problem of Thrust Master Yoke Boeing Edition

[tayo]

Hello everyone.
I have a big problem about my TCA Yoke Boeing Edition.

＜Environment＞
P3D V.5.3
WINDOWS 11

Add On : PMDG B737-800
：FSUIPC6

＜Problem to solve＞
Whenever I use my yoke to control pitch or bank angle, regardless of it’s input force,
only the right seat control column or control wheel moves to full forward /backward or full left/full right.
What is causing this problem?
What should I do to solve this matter?

I greatly appreciate your kind support.
Thank you.

[Martyson]

Hello tayo ,

Your “Image” did not show up?

How to Post Screenshots (by Chris Metel):
https://www.prepar3d.com/forum/viewtopi ... 98#p238598



Just to verify:

Is your that your PMDG737-800 is the PMDG737-800 NGXu ?

What is your PMDG yoke Option set to in the PMDG CDU Options?

Is your First Officer’s yoke in the “lowered” position?

[tayo]

Hello, Martyson
Thank you for your reply.

>Is your that your PMDG737-800 is the PMDG737-800 NGXu ?
・That is the PMDG737-800 NGXu.

>What is your PMDG yoke Option set to in the PMDG CDU Option ?
・Sorry I am not sure about Options.
　What kinds of Options are there in PMDG yoke and CDU?

Is your First Officer’s yoke in the “lowered” position ?
・I am not familiar with the yoke position "lowered".
Where can I check or select that position on the simulator ?

I greatly appriciate your kind support.
Thank you.

[Martyson]

Hello tayo ,

You are welcome.

Read the PMDG Introduction document located here / on my setup it is drive "D":
D:\Prepar3D v5\PMDG\PMDG 737 NGXu\Flight Manuals

FCOM, QRH and Tutorial documents are also in the same folder.

[tayo]

Hello Martyson,

Thank you for your useful information.
I will check that document soon.

I wish my yoke will become normal.

I greatly appreciate your help.
thank you.