Do you have a solution for me ?

[Quares631]

Hello,
Since I passed from V5.2 to V5.3 and since then I have a texture problem on Landscape ORBX scenery.
I have lots of colorized rectangles...

I already tried this :

1b. If your Orbx Libraries are installed into an Orbx Central Library, please do not rename
Scenery\BASE\Scenery\lclookup.bgl to lclookup.bgl .off

2. Rename C:\ProgramData\Lockheed Martin\Prepar3D v5\terrain.cfg to terrain.cfg.off

3. Run P3D v5 once to create a new terrain.cfg file and close it.

4. Then run Settings\Help\Sync Simulator in Orbx Central which will write back the Orbx entries.

5. Then try P3D again.

But the problem is still here.
Do you have a solution for me ?

Thank You
Fabien

[JorgenSA]

Fabien,

Since this is ORBX, you might want to ask the question in the ORBX P3D forum here:

https://forum.orbxdirect.com/forum/129-prepar3d/

Jorgen

[shermank]

Fabien,

Since this is ORBX, you might want to ask the question in the ORBX P3D forum here:

https://forum.orbxdirect.com/forum/129-prepar3d/

Jorgen

The above link is dead. This will take you to ORBX support for p3d.v5. But just as a note, there has been discussion on the general ORBX forums about a lack of support for recent inquires. But, it is worth a try

https://orbxsystems.atlassian.net/servi ... group%2F-1

Sherm

[alaxus]

You can try this.
https://www.youtube.com/watch?v=auM4phPVarY

FWIW I get the psychedelic tiles as well.

[pestridge77]

Hello,
Since I passed from V5.2 to V5.3 and since then I have a texture problem on Landscape ORBX scenery.
I have lots of colorized rectangles...

I already tried this :

1b. If your Orbx Libraries are installed into an Orbx Central Library, please do not rename
Scenery\BASE\Scenery\lclookup.bgl to lclookup.bgl .off

2. Rename C:\ProgramData\Lockheed Martin\Prepar3D v5\terrain.cfg to terrain.cfg.off

3. Run P3D v5 once to create a new terrain.cfg file and close it.

4. Then run Settings\Help\Sync Simulator in Orbx Central which will write back the Orbx entries.

5. Then try P3D again.

But the problem is still here.
Do you have a solution for me ?

Thank You
Fabien

Head into Orbx Central and click verify on the Orbx Libraries and Object Flow. Then reset your insertion point. Close Orbx down and delete the scenery indexes which can be found in C:\ProgramData\Lockheed Martin\Prepar3D v5\SceneryIndexes_x64 and then have a look.