[RESOLVED] Heading Issue
Re: Heading Issue
Are the fsAerodata mods still in use on your P3D setup?
Best Regards,
Vaughan Martell PP-ASEL (KDTW)
Vaughan Martell PP-ASEL (KDTW)
Re: Heading Issue
You have something that has messed up your scenery.
You need to remove all addons from your sim so that there is nothing but the base sim provided by L-M. This means you will have to uninstall absolutely everything. After uninstalling Prepar3D, ensure that there are no folders left where the sim was installed. If there are, delete them. You can not have anything left over from your install before installing Prepar3D again. Then once you have a clean installation, check the magnetic heading values. Add each addon in, one at a time... check the magnetic heading values after each install. It is the only way you are going to find which addon is corrupting the sim.
You need to remove all addons from your sim so that there is nothing but the base sim provided by L-M. This means you will have to uninstall absolutely everything. After uninstalling Prepar3D, ensure that there are no folders left where the sim was installed. If there are, delete them. You can not have anything left over from your install before installing Prepar3D again. Then once you have a clean installation, check the magnetic heading values. Add each addon in, one at a time... check the magnetic heading values after each install. It is the only way you are going to find which addon is corrupting the sim.
Ed Wilson
Senior Developer
Mindstar Aviation
Senior Developer
Mindstar Aviation
Re: Heading Issue
If it is an add-on issue, could I start with the most recent add ones and delete backwards? Would that uncover the problem? I wouldn’t want to waste my time if that would not work. But I would also like to avoid the nuclear option if possible.
Re: Heading Issue
You could try that first, it's up to you.
The general debugging steps are here:
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
Also helpful :
Are the links to LM guide for Uninstalling / Reinstalling P3D
http://www.prepar3d.com/forum/viewtopic ... 2&t=125187
http://www.prepar3d.com/forum/viewtopic ... 2&t=120676
Best Regards,
Vaughan Martell PP-ASEL (KDTW)
Vaughan Martell PP-ASEL (KDTW)
Re: Heading Issue
Thanks. I appreciate the help.