The standby frequency switches do not seem to work and the tuning knobs are upside down.
I tried swapping out the complete aircraft and cab files from V3 but they still don't work.
P4 Carenado A36 Radio Standby Switches
P4 Carenado A36 Radio Standby Switches
Dave Opper
ESSB
ESSB
Re: P4 Carenado A36 Radio Standby Switches
I have the same problem - in v4 the clickable standby switches are completely non-functional in both GPS units.
Re: P4 Carenado A36 Radio Standby Switches
I wound up piggy backing the Bendix radio from the Beech Baron 58 in a special popup window. Tuning that one tunes the other.
At least I can fly IFR again.
At least I can fly IFR again.
Dave Opper
ESSB
ESSB
Re: P4 Carenado A36 Radio Standby Switches
on a similar topic. .
On V3 this worked fine but on P3D V4 I cant change the 2nd digit on the ADF ?
On V3 this worked fine but on P3D V4 I cant change the 2nd digit on the ADF ?
Re: P4 Carenado A36 Radio Standby Switches
Same here! unable to switch freqs (active/backup) nor changing the second digit of ADF...
Re: P4 Carenado A36 Radio Standby Switches
same issue here with the being able to tune freq. Apparently there are all kinds of issues with functional components of Carenado aircraft according to their website. Hope they'll get this fixed
David Blitch
KVCB
KVCB
Re: P4 Carenado A36 Radio Standby Switches
any update on this, its really frustrating not being able to use the ADF unless you frequency has a 8 or 0 at the end!
Re: P4 Carenado A36 Radio Standby Switches
Same here on the default Bonanza AND apparently I have the same issue on the (carenado purchase) Piper Seneca V with the same GPS/Radio (GNS430).
Im in contact with Carenado, but they claim they cant repeat the problem......
But apparently there is an issue with it.
Im in contact with Carenado, but they claim they cant repeat the problem......
But apparently there is an issue with it.
Re: P4 Carenado A36 Radio Standby Switches
Is Prepar3d or Carenado ready to do something about it or do they just let it run?
- Brady Butler
- Lockheed Martin
- Posts: 965
- Joined: Tue May 09, 2017 5:31 pm
Re: P4 Carenado A36 Radio Standby Switches
In regards to the ADF being stuck with 8 or 0, are you using the mouse wheel to change the numbers? When you left click on the front knob it changes from using 1's to TENTHS and the back knob changes 10's to 100's. I'm able to change all the numbers on default Prepar3D this way.
Regards,
Brady
Regards,
Brady
Brady Butler
Prepar3D® Software Engineer
Prepar3D® Software Engineer