[RESOLVED] P3D et Hotas WARTHOG

[Djoser]

Hello

I appeal to you to try to solve a problem with P3d>
My whole HOTAS + joystick + rudder is well recognized>
By P3D tale does not operate a single element.>
If I plug the single joystick it works>
If I plug the throttle only gas it works>
If I connect the two, only the joystick works !!!!>
Would you have a solution for me?

(All works fine on X-plane. This is not a hardware problem)

Thank you

Sorry for my broken English

[Mike LM]

Djoser -

Which drivers are you using? How did you calibrate the hardware?

- Mike

[downscc]

It is best to not use the Thrustmaster drivers or TARGET GUI software with P3D after v3.0.

I am using the Warthog HOTAS stick and throttle controls with P3Dv3.x without problem. Calibrate axis and assign buttons within P3D. Only exception I found is if key commands are needed from a button push FSUIPC is used for that, for example for PMDG Options Menu key commands.

[Djoser]

Thank you for your answers
@Mike: I use the drivers 2014_TMHW_1.exe

@ Downscc: I do not use TARGET
For calibration, no problem for the joystick in P3D
But for the throttle, I can not calibrate because nothing happens when I maneuver the throttle or I press the buttons

If you have an idea ???

[Fervex]

Did you try this? http://ts.thrustmaster.com/download/acc ... arthog.rar
It works with FSX and p3D V3.x

[Djoser]

Hello

Thank you all for your help
My problem is solved. He had to go through the programming TARGET.
I installed, as Fervex said, FSX_Combat_Pilot_Warthog.rar
After I was able to set TARGET when looking around.
P3D starting from TARGET everything is now OK

Again thank you to the community

Cordially