[RESOLVED] Clean P3Dv4.4 installation
[RESOLVED] Clean P3Dv4.4 installation
I completely uninstalled the previous version, 4.3, and did a clean installation of the new version. I don't know if this is normal, but all my .config changes, addons, and settings from the previous version were saved. I checked the version I now have installed, and it shows V4.4. Is this normal or is there something I need to do. Thanks.
Pete Locascio
- Brady Butler
- Lockheed Martin
- Posts: 965
- Joined: Tue May 09, 2017 5:31 pm
Re: Clean P3Dv4.4 installation
Hello Tamba765,
This is expected behavior. If you'd like a fresh start, you could delete your generated files following step 5 of the general debugging steps, but I don't believe it's necessary unless there are problems that arise.
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
Regards,
Brady
This is expected behavior. If you'd like a fresh start, you could delete your generated files following step 5 of the general debugging steps, but I don't believe it's necessary unless there are problems that arise.
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
Regards,
Brady
Brady Butler
Prepar3D® Software Engineer
Prepar3D® Software Engineer