[RESOLVED] lag and freeze when switch to outside camera

[AmirabbasDr]

hi.i using p3d for 4 years and now i have p3d v4
the sim when i switch to outside camera like wings or engines its get very laggy and freeze.when i mute and unmute the lag goes off in cockpit but not in outside.
also when i pick a light aircraft like c172 or piper or... its get laggy too but don't goes off with mute and unmute
sorry for my bad english :D
i can rec a video to show that problem too if needed

[Brady Butler]

Hello AmirabbasDr,

To have us assist you further, could you please review this topic and let us know the results from following the troubleshooting steps? Also, can you provide the details of your system?

http://www.prepar3d.com/forum/viewtopic ... 2&t=123246

If the issue is determined to be caused by an add-on, you will likely want to reach out to the add-on developer for direct support. If they need any support with development, they should not hesitate to contact us.

Regards,
Brady

[AmirabbasDr]

hi brady.
i also did the all debug and troubleshooting but didn't changed anything!
my p3d version 4.5 professional
CPU: CORE I5 7400
GPU: GTX 1050 Ti Strix oc 4gb
RAM: 8GB DDR4
HARD:1TB
POWER:460 COOLER MASTER
MOTHERBOARD: B250F GAMING STRIX
thats my config.
the problem is not for my addons is from p3d.
i tested that

[Brady Butler]

Hello AmirabbasDr,

Was v4 working on your system normally at one point?

Did you change something with your setup from when it was working normally to when it started having issues?

Regards,
Brady

[AmirabbasDr]

hi brady.
i did not changed anything on my system
when i mute unmute in cockpit its get good but i can't change camera to outside because of freez and lag

[AmirabbasDr]

does anyone know the solution for this?
i'm so bored and tired about this problem.i tried everything

[Martyson]

does anyone know the solution for this?
i'm so bored and tired about this problem.i tried everything

Is your default P3D flight the LM F22 at KVPS?

If you test with the default F22 do you have the same problem?

You mentioned "also when i pick a light aircraft like c172 or piper"
Are these FSX aircraft imported into P3D?

Are you using Add-on software to switch views?

[AmirabbasDr]

i used default aircrafts to know that is for p3d not for addons.
i do not imported any fsx addons to p3d

[Brady Butler]

Hello AmirabbasDr,

Be sure that you completed all of step 5 in the general debugging steps.

Do you have other programs running while Prepar3D is running?

Have you opened task manager to see if something else is eating a significant amount of CPU cycles?

Regards,
Brady

[Simbol]

For what is worth, I have seem people with similar issues due to HDMI sound drivers under NVIDIA settings.

Try updating all your NVIDIA drivers, sound dirvers and then disable any HDMI sound devices under NVIDIA settings.

S.

[AmirabbasDr]

i will do that right now thanks for Your advise

[AmirabbasDr]

i did that and yessss. finaly it get fixed. thanks brady and simbol
best regards