[RESOLVED] right mouse click not working in v4.2
-
- Posts: 12
- Joined: Sat Oct 14, 2017 8:38 pm
[RESOLVED] right mouse click not working in v4.2
After upgrading to v4.2, the right click of my mouse is not working (but it works fine outside prepar3d).Can someone help with this annoying occurrence please? Thank you very much
- Brady Butler
- Lockheed Martin
- Posts: 965
- Joined: Tue May 09, 2017 5:31 pm
Re: right mouse click not working in v4.2
Hello,
To have us assist you further, could you please review this topic and let us know the results from following the troubleshooting steps?
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
If the issue is determined to be caused by an add-on, you will likely want to reach out to the add-on developer for direct support. If they need any support with development, they should not hesitate to contact us.
Regards,
Brady
To have us assist you further, could you please review this topic and let us know the results from following the troubleshooting steps?
http://www.prepar3d.com/forum/viewtopic ... 2&t=123246
If the issue is determined to be caused by an add-on, you will likely want to reach out to the add-on developer for direct support. If they need any support with development, they should not hesitate to contact us.
Regards,
Brady
Brady Butler
Prepar3D® Software Engineer
Prepar3D® Software Engineer
-
- Posts: 12
- Joined: Sat Oct 14, 2017 8:38 pm
Re: right mouse click not working in v4.2
The problem was due to a third party addon.Removal of this addon solved the problem.