[RESOLVED] View Groups in P3d v4 with Immersive Display / Calibration

[jim05]

Hello,
yesterday I‘ve finished the calibration of my 220 degree curved screen with immersive calibration. Everything worked fine. I got a more or less good grid and test-image over my 3 projectors. I use 2 Gpus 980ti an disabled sli.
At the end of the calibration-process i calculated the setup and produced the viewgroup-file, which i placed in the folder of p3d.
But something went wrong. When I start immersive display and p3d i get this picture:

https://ibb.co/jRKn4JV
https://ibb.co/pPJX1dx


I don‘t know, what i could do now, to fit this problem....

Perhaps someone could give me an advise, to solv this problem.
Ah... and i don‘t know, why the projector 2 has the ID2, the projector 3 has the id3, but the projector 1 has the id4!? Why not id1?


Best regards,
Christian

[jim05]

... everything is right now.
I solved my problems!

Christian

[Poppet]

For other users reading this post, The link below has some helpful Information on how to setup View Group for Prepar3D v4

https://www.prepar3d.com/forum/viewtopi ... 6&t=129111