Maybe you are using an add-on that adds these entries into your p3d.cfg? There are some add-ons out there that tweak the configuration file. Which add-ons are you using?

If you have 1700 MB VAS left while he gets an OOM flying the same route with a similarly complex airliner, something must be very different with regard to the computer system and add-ons installed. You might refer to this post by Adam Breed, where he gives some tips on what you can try to address th...

+1 I also appreciate your detailed and reproducible description of the phenomenon, which has helped LM identify the bug. This is refreshing and constructive amid a huge number of posts that complain that they have an OOM, but do not provide specific steps on how to reproduce the error or even list t...

If you have installed v3.2, you need to uninstall the client related to v3.2. Then you can directly install the v3.4.18 client (it usually takes a few seconds).

So you have tried to add the entry that I have mentioned? Can you post your p3d.cfg?

You can try to add the following command in your p3d.cfg below the section [CONTROLS]:

Stick_Sensitivity_Mode=0

Once you have done that, make sure to set your sensitivity sliders in the p3d menu all the way to the right.

Let me know if this helps.

I can also confirm this behavior. Limiting the frame rate internally to any value results in a creep-up of VAS over time until an OOM is triggered. When the frame rate is not limited, the VAS goes up but stabilizes at some point. Out of interest, I have rolled back the client to v3.2 and deleted all...

I'm afraid it's not possible to change settings at startup directly...

However, you can load a settings profile at startup (that you need to have saved before). Hope that helps.

Dear LM-Team, I wanted to bring to attention a problem that has existed for a while in Prepar3D: The green taxiway center lights at default airports during night are floating above the ground and seem too high. Please refer to this video (which I made while taxiing at KORD) to see what I am talking ...

Do you have all autogen buildings popping up (even small ones), or only tall buildings or skyscrapers? I know that the pop-free autogen feature only applies to autogen buildings, non tall inner city buildings (that are affected by "Scenery Complexity" settings). Also, when you reinstalled ...

It is definitely better to install Prepar3D on your SSD (=faster loading times) under [Drive Letter]:\P3D\...

Have you tested Prepar3D before installing the scenery add-ons to find out whether you had the autogen popping with a fresh installation? This would help diagnose whether it is due to P3d itself or whether an add-on messed up with your setup. For instance, I see an entry in your prepar3d.cfg that is...

I have conducted my favorite test flights from KIAD to KJFK using ConcordeX and AS2016 after having updated the Client from v3.2 to 3.4, and I can say that the VAS consumption in v3.4 has NOT been noticeably higher overall than in v3.2 (in some segments it was even lower) despite having OpenLC NA in...

Which weather program are you using? Do you also use ASCA?

If I get very close to the engine (by pressing ctrl and -), I also hear more distortion than from the default distance in the external view. I have not even noticed the distortion previously, because I assumed that it was natural for turboprops... Have you brought up this issue in the official MJC f...