Page 1 of 1

P3D ATC doesn't recognize "Num1"

Posted: Fri May 31, 2019 9:40 pm
by ncngrr
On P3Dv4.5 (without the Hotfix).

I installed a small number keypad on my instrument panel so that I could simply push a number button to select an option from the default P3D ATC menu (announce taxi, position, on final, etc.)

Was disappointed when P3D ATC didn't recognize those button pushes. Used the number keypad on my keyboard, same thing. Used the number across the top of the keyboard, it worked correctly.

Went to registered version of FSUIPC and saw that when I press the numbers across the top of the keyboard, FSUIPC registered the press as a "1", "2", ....

When I pressed the numbers on the keypad (either on the keyboard or the separate keypad), FSUIPC registered the press as a "Num1", "Num2", etc...

I confirmed NumLock is turned on... on both keypads. Tried it turned off as well, just because.

What must I do to get P3D to respond appropriately to the keypad entries? I'm trying to remove the keyboard altogether from my cockpit... it's been an elusive goal!

Thanks.
Scott