I want to install a SALS and Descentometer gauge in P3DV4.5 but they don't show up in the cockpit anymore since I upgraded to V4.5 they show up in the panel manager and checked off but not in the cockpit .
Used to work fine till I updated V4 Work fine in FSX any suggestions I am putting everything in the panek cfg and the cab files in the gauge folder as well like I always did
Is this a block by Lockheed Martin ?? If so I guess ill have to go back to the old FSX and forget about P3D.
Other problems or issues not covered by other troubleshooting topics.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests