Page 1 of 1

year 2013 and FPS ...

Posted: Thu May 14, 2020 9:50 am
by 312Ejder
year 2013 ...
I bought prepar3d v1.

year 2014 ...
maybe in the hope of a change in fps ...
I bought prepar3d v2.
unfortunately I realized that they could not do this job.
I started using Xplane because I'm tired of dealing with the cfg file for fps.

year 2020 ...
I bought prepar3d v5.
fps 30 after clean installation.
p3d alone will not work. so we load orbx and pmdg. and 6 years later fps 20.
naturally my question is ... what are you doing there? Is it difficult to use gpu and cpu? I get 60 fps in dcs with my current computer. you kill our passion for aviation.

Re: year 2013 and FPS ...

Posted: Thu May 14, 2020 9:53 am
by JorgenSA
System specs?

And I do assume that you did not just load your old ORBX and PMDG stuff into v. 5?

Jorgen

Re: year 2013 and FPS ...

Posted: Thu May 14, 2020 10:52 am
by 312Ejder
PMDG 747-800 for v5 ... Orbx Global for v5 ...
(i7 4930k) (32GB RAM) (GTX1080 11GB) (m2 1800MB/s) 1080p...

p3d cannot use my video card... Video kartım uçuş sırasında fanı bile açmıyor.

but in xplane and dcs, my video card is turning on the fan. because they use my graphics card ...

You should learn to use the system to ask people about hardware features...

Re: year 2013 and FPS ...

Posted: Thu May 14, 2020 10:59 am
by JorgenSA

Re: year 2013 and FPS ...

Posted: Thu May 14, 2020 11:18 am
by 312Ejder
Thank you very much ... We are back in 2013 ...

Re: year 2013 and FPS ...

Posted: Thu May 14, 2020 2:01 pm
by funknnasty
312Ejder wrote: Thu May 14, 2020 11:18 am Thank you very much ... We are back in 2013 ...
Dude!
Your mobo, ram and cpu are so 2013. So as long as you're anchored in the past you'll never come to terms with the present ....the P3D V5 recommended specs; which is highly recommended when you start adding complex aircraft and demanding scenery.

Re: year 2013 and FPS ...

Posted: Sun May 17, 2020 11:24 pm
by Alox
Hi

Most of my hardware are from 2011 and I can run it very well with setting middle to high in p3dv5 and Nvidia Inspector.

Some Add Ons: Global Base Pack, Open LC North, Tress hd, Buildings hd, FS Gun 2020, Cessna 182 A2A with reality XP GNS v2, MMMD MexHighFlight, Sky Force, etc.

Spec:
I7-4930 4.1 Ghz.
DDR3 48 GB 1600 Mhz.
RTX 2080 Super.
Rampage IV Extreme.
Power Supply Corsair 850.

Settings that kill my performance:
Traffic. ------> Off.
Autogen bulding density. -------> Sparce.
Dynamic reflections. -------> Off.

I almost have 29-30 Fps.

https://www.dropbox.com/s/r69n8mcrziriljb/MMMD.jpg?dl=0

Regards.