[RESOLVED] After changing input method two axis don't work anymore

Any issues, problems or troubleshooting topics related to computer hardware and the Prepar3D client application
PME
Posts: 5
Joined: Mon Feb 09, 2015 2:17 pm

[RESOLVED] After changing input method two axis don't work anymore

Postby PME » Fri Feb 08, 2019 5:10 pm

At the moment I use P3Dv4.4.
The axis of my GoFlight Throttle Quadrant work through FSUIPC. I have switched the controlers off in Prepar3D. After switching the input control (Options>Other>Input Method) from DirectInput to Raw Input two of the axis don't work anymore. They have no range in FSUIPC. The other axis work well (throttles, rudder, elevators and ailerons).
What went wrong, apart from being so stupid to change the input control, and what can I do to get both axis working again. It looks like the two pot meters are destroyed.
Peter v. d. Meule, Netherlands

PME
Posts: 5
Joined: Mon Feb 09, 2015 2:17 pm

Re: After changing input method two axis don't work anymore

Postby PME » Sat Feb 09, 2019 8:28 pm

My question is answered. Both axis are working properly again. I just had to recalibrate the two axis that were messed up, in Windows (Devices and Printers).


Return to “Hardware Specific Questions”

Who is online

Users browsing this forum: Baidu [Spider] and 6 guests