At the moment I use P3Dv4.4.
The axis of my GoFlight Throttle Quadrant work through FSUIPC. I have switched the controlers off in Prepar3D. After switching the input control (Options>Other>Input Method) from DirectInput to Raw Input two of the axis don't work anymore. They have no range in FSUIPC. The other axis work well (throttles, rudder, elevators and ailerons).
What went wrong, apart from being so stupid to change the input control, and what can I do to get both axis working again. It looks like the two pot meters are destroyed.
Peter v. d. Meule, Netherlands
Any issues, problems or troubleshooting topics related to computer hardware and the Prepar3D client application
2 posts • Page 1 of 1
My question is answered. Both axis are working properly again. I just had to recalibrate the two axis that were messed up, in Windows (Devices and Printers).
Who is online
Users browsing this forum: No registered users and 11 guests