Prepar3D Forums

I find that the switches for Com and Vloc are not working on the GNS.
The switches depress but the freq do not change.
Hope you can help.
Kind regards
Richard

Sorry, I should also have said that this is for the Carenado A36 BONANZA in P3D v4.
Regards

It's the same with me, the engine start command does not work ...
Thank you.

Using P3D v4 I find in the Carenado A36 Bonanza that the switches for Com and Vloc are not working on the GNS.
The switches depress but the freq's do not change.
Hope somebody can help.
Kind regards
Richard

Hi Richard,

They appear to be working for me. After turning on the GNS I am able to switch both COM and VLOC frequencies using the buttons on the left. Are you seeing this issue with the VC gauge, the 2D gauge, or both?

Thanks.

Hi,

I'm sorry, but don't have good news. My P3DV4 was purchased on the first day and, since then, I've flown only the Bonanza to test how my Orbx sceneries are doing. Since then, the Garmin freq switches were working perfect.

Yesterday I installed the unregistered version of FSUIPC only to see which features I could have. Today morning, I went to fly the Bonanza to proceed along North California region. The freq switches were NOT working, neither on 3D nor in 2D.

I thought what could've happened - the new kids on the block were the new EditVoicePack and FSUIPC5. I know from FSX that FSUIPC is bugged for some aircraft and it has a lot of interference on the platform.

So I removed all FSUIPC files from the Modules folder and restarted. The freq switches are working again.

I will communicate this on Peter Dowson forum.

Best
Heron Domingues Jr

Thank you Heron Domingues Jr Getting rid of FSUIPC has done the trick. Good stuff.
Kind regards
Richard