I have a 3 projector, curved screen cockpit set-up (135 degrees) using FS X. I had to purchase the Warplizer software in order to correct the distortion problems of a curved screen.

While the Warpalizer worked just fine for FS X, the D3D9.DLL file from that program that one has to copy into the P3D main folder causes P3D to crash every single time. I get a black screen at the beginning and then a notice stating the program has crashed with Windows looking for a solution. Of course no solution is found. If I remove that file, P3D starts just fine. Of course it's unflyable in this situation due to the severe screen image distortion.

Has anyone experienced this problem between Warpilzer and P3D. I am awaiting a similar answer from the Warpalizer support group as well.

Harry

Hi Harry
Try opening a flight without the d3d9 file, go to full screen mode then exit p3d so that when you place the d3d9 back and start p3d it starts in full screen mode... i had same problem and this worked for me.

James