First question before I start - will Lockhead release a version of the Learning Center as a Standalone? Would be handy as I am not always on the Flight Simulator PCs when I want to investigate issues.

Anyway, main question. Need a configuration for the following setup of screens.

Master

Slave will be the visuals looking forward and only forward on a single projector at present.

The Master has the screens setup in Windows 7 the same as what is depicted in the image above.

The two middle screens have the dimensions of 1920x1080 (Front Panels)

The top screen has a screen size of 416x693 (Overhead)

The bottom screen is 600x600 (Centre Pedestal)

Top and bottom screens are touch screens which show the overhead and centre pedestal avionics. The Aircraft is a Bell 412 EP.

The Panels are cut outs with a custom panel config so that the screen sits behind them showing the gauges. Works very nicely.

Slave:

This is a projector (haven't got what its resolution was however it is only one single screen. We are not creating a dome or concave screen as yet. We may in the future.

So, we need to setup the multi-channel with these many screens on the master unit and a single on the slave.

Anyone already have a configuration for something similar to this?

Many thanks.

As I understand is that -what you called Slave- is showing a New View-Cockpit-Virtual Cocpit view
Connect the third monitor (your projector) to the video card where the 2x 1920 is connect; you should have 3 connections there.
Undock the View; remind that the frame rate drops 50% with single screens
OR
Make an Eyefinity group of 3 and resize the new view within the limitations of what you get then (1920+1920+??projector))

We have a problem running Prepar3D with a triple front display and one cockpit display. The PC is set up correctly both in windows ans AMD Catalyst(6950 card). The triple screen and cockpit run fine in FS X.
In Prepar3D it:
1. Will not open the Instrument Panel display for the lower screen and it does not appear in the new view options. Only the GPS, Radios ect are there.
2. When set up for the triple from display when i hit the "Full Screen" the display reverts back to duplicate screens rather than extended display.

We want to have a triple front display and the cockpit display needs the instrument panel, GPS and Radios.
We have removed Prepar3D and are reloading it to the PC today.

It hasn't been removed, there have been some threads on this one with a workaround, we are looking into it. Jim, if you have any more feedback, especially on the transparent additional panel workaround that was posted please let us know.